Table of Contents
Advertisement
■ Receiving and transmitting
CAUTION: Transmttng wthout an antenna may damage
the transcever.
q Push and hold [PWR] to turn power ON.
w Set the volume and squelch levels.
➥ Push [SQL•
], and push [–] to open the squelch.
MONI
➥ Push [SQL•
] to stop "SQL" ndcator blnkng, then
MONI
push [+]/[–] to set the volume level.
➥ Push [SQL•
], and push [+]/[–] to set the squelch
MONI
level.
e Push [Y]/[Z] to select the desred channel.
- When recevng a sgnal, "
from the speaker.
- Further adjustment of the volume may be necessary at ths
pont.
r Push [H/L•
] to select the output power f necessary.
LOCK
- "LOW" appears when low power s selected; no ndcaton when
hgh power s selected.
- Choose low power to conserve battery power, choose hgh
power for longer dstance communcatons.
- Some channels are for low power only.
t Push and hold [PTT] to transm t, then speak nto the
mcrophone.
-
"
" appears.
- Channel 70 cannot be used for transmsson.
y Release [PTT] to receve.
" appears and audo s emtted
BASIC OPERATION
IMPORTANT: To maxmze the readablty of your trans-
mtted sgnal, pause a few sec. after pushng [PTT], hold
the mcrophone 5 to 10 cm from your mouth and speak
nto the mcrophone at a normal voce level.
NOTE: The transcever has a power save functon to
conserve the battery power. The power save functon ac-
tvates automatcally when no sgnal s receved for 5 sec.
t Push to
transmit
y Release to
receive
Microphone
eÊSet channel
4
4
q Power ON
r Set output
power
w Set volume
w Set the
squelch level
w Set the squelch
level
10
Advertisement
Table of Contents
