Table of Contents
Advertisement
The Model W1715 can easily be set up for vertical cutting
operations to make cuts that are not a straight cut
through the entire workpiece, such as curves or pattern
cuts.
DISCONNECT BANDSAW FROM POWER!
Remove the two flat head screws and the blade
guide cover shown in
Install the table and replace the two screws removed
in
.
Install the table bracket with the pre-installed hex
bolt, the M6-1 x 12 flat head screw, and the M6-1
hex nut, as shown in
Place a level on the table, as shown in
then use the adjustment bolt shown in
make the table level.
.
.
,
to
-20-
Blade
Guide
Cover
Blade guide cover.
Table and table bracket
installed.
Adjusting table with a level.
Adjustment
Bolt
Table adjustment bolt.
Bolt Already
In Casting
Advertisement
Table of Contents
