Table of Contents
Advertisement
On the other leg, insert the handle into the pre-
drilled holes and secure it with the cotter pins (see
).
Cotter
Pin
With the help of an assistant, lift the bandsaw onto
a pair of closely spaced sawhorses or other suitable
Handle installed with cotter
support (see
).
pins.
Attach the legs to the bandsaw with the M8-1.25 x
25 hex bolts, 8mm flat washers, and M8-1.25 hex
nuts. Tighten them with a 14mm wrench or socket
just enough to secure the parts. Final tightening will
take place when the stand is fully assembled.
Remove the machine from the sawhorses, then
install the tool tray in the middle of the stand with
the M6-1 x 12 Phillips head screws, 6mm flat washers
and M6-1 hex nuts, as shown in
.
Check to see if the bandsaw is relatively level, then
final tighten all the nuts.
Attaching leg assemblies.
Installing tool tray.
-14-
Advertisement
Table of Contents
