Gap In Captured Signature; No Response From The Touch Screen - VeriFone MX800 Series Installation Manual

Gap in Captured
Signature
No Response
From the Touch
Screen
NOTE
The following are the corrective steps to be taken if there is a gap in captured
signature. (This procedure does not apply to the MX830 terminal without touch
screen.)
1
Ensure that the stylus is pressed hard during signature capture.
2
If the problem persists, contact your local VeriFone representative for
assistance.
The following are the corrective steps to be taken if the touch screen does not
respond or displays the incorrect response. (This procedure does not apply to the
MX830 terminal without touch screen.)
The MX800 Series terminal requires a touch screen calibration at the time of
installation. The terminal should be powered on and allowed to stabilize at normal
operating temperature; usually this takes no longer than 30 minutes, even if the
terminal was previously in a cooler or warmer location. The touch screen
calibration procedure (below) should then be performed.
To perform a touch screen (panel) calibration, follow this procedure:
1
Press the recessed button near the top of the Magnetic Stripe Reader with a
straightened paper clip and hold while three LEDs in the MSR track turn on.
Release the button when the middle LED turns off. Keep hands away from
the display until the prompt appears for password entry.
2
Enter the password.
3
In System Mode, perform a manual touch screen compensation. Tap
> right blue arrow >
CONFIGURE
on the display.
4
If the problem persists, contact your VeriFone representative for assistance.
>
CALIBRATE CALIBRATE
MX800 S
ERIES
. Follow the directions
I G
NSTALLATION UIDE
25