Control Functions; Control Panel - Sundance Spas 780 series Owner's Manual

8.0

Control Functions

8.1

Control Panel

A. LED Display: Can display
current water temperature
(default display), water
temperature set point, selected
filtration/heating mode, and error messages.
B. Heat Indicator: Lit when heater is on.
C. Warmer (
D. Cooler (
E. Jets 1 Button: Turns jets pump #1 on and off. Press once for low
speed; press a second time for high speed; press a third time to turn
pump #1 off.
F. Jets 2 Button (if equipped): Turns high-speed jets pump #2 on and
off. Press once to turn on; press a second time to turn pump #2 off.
G. Light On/Off Button: Turns waterfall, footwell, and air control lights
on in unison. Press once for high intensity; press a second time for
medium intensity; press a third time for low intensity; press a fourth
time to turn off. The displayed color is changed using the light mode
button (H) below.
H. Light Mode Button: Selects one of 4 color modes for waterfall,
footwell, and air control lights. See page 27 for additional
information.
Operation Details
• Temperature Adjustment: 65-104°F (18-40°C). Factory default setting
is 100°F (38°C).
• All lighting systems run for 2 hours then shut off.
• Jets 1/Jets 2 Button Operation: Jets run for 20 minutes after
activated, then turn off automatically to conserve energy. Simply
press either jets button to continue operation for an additional 20
minutes.
) Button: Increases water temperature set point.
) Button: Decreases water temperature set point.
A
C D E
B
1
2 Pump Panel Shown
780 SERIES
F G H
2
Page 23