Completing The Installation Of A Processor - HP Vectra VE 5/series 2 User Manual

COMPLETING THE INSTALLATION OF A PROCESSOR

1 Verify that the system board bus speed switches are correctly configured for the
processor.
Switch 4 Switch 5
ON OFF
OFF OFF
ON OFF
OFF OFF
NOTE
1 Install any other accessories before completing the installation of the processor.
2 Replace the cover (see "Removing and Replacing the Cover" earlier in this chapter).
3 Turn on the computer and check that the new processor is recognized by the power-on
system-test.
Switch 6 Switch 7
ON OFF
ON OFF
OFF ON
OFF ON
If two processors are installed, both must operate at
the same bus speed and processor speed. Refer to
the manual supplied with the processor to verify
which bus and processor speeds are supported.
Note that you must configure your operating system
to use the second processor. Some operating
systems do not support two processors.
Bus
Switch 8 Speed
OFF 60 MHz
OFF 66 MHz
OFF 60 MHz
OFF 66 MHz
Processor
Speed
150 MHz
166 MHz
180 MHz
200 MHz