Part Identification Chart - NordicTrack NTEX08011.1 User Manual

PART IDENTIFICATION CHART

Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the
key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it
has been preassembled. Extra parts may be included.
M8 Split
M8 Locknut
M6 Washer
M10 Locknut
M8 Curved
Washer (93)––6
(90)––4 (88)––4
(91)––6
Washer (86)––2
M4 x 16mm
M6 x 16mm M8 x 18mm
M4 x 19mm Tek M4 x 38mm
Screw (77)––7
Screw (75)––2 Screw (89)––2 Screw (71)––4 Screw (67)––4
M8 x 68mm Bolt (70)––2 M10 x 60mm Bolt (99)––2
M8 x 35mm Bolt (72)––2 M10 x 96mm Bolt (65)––4
7