Kodak i4000 Plus Series User Manual page 41

A-61651 August 2013
Lower imaging guide
7. Turn the screw to the left on each end of the lower imaging guide and
remove it from its position. Set the imaging guide aside.
8. Carefully vacuum the area between the LEDs.
IMPORTANT: Avoid contact with the LEDs, as contact could cause
damage. Do not insert any objects into the area between the
upper LED strips, as you may damage the reflective mirrors
in the scan module on the illumination system.
9. Clean both the top and bottom of the lower imaging guide thoroughly with a
Staticide wipe.
10. Wipe the imaging guide again with an almost-dry Staticide wipe to remove
any streaks.
11. Reinstall the lower imaging guide.
12. Close the scanner cover.
13. When finished with all cleaning procedures, turn on the scanner.
5-9