Configuring Hp P6000 Command View (Advanced Tasks); Setting User Interface Options; Creating Page Footer Messages - HP P6000 User Manual

8 Configuring HP P6000 Command View (advanced tasks)

This chapter describes configuration options for the HP P6000 Command View user interface and
is for advanced tuning only.
For information about other configuration options available from the Server options window, see
the HP P6000 Command View online help.

Setting user interface options

To set user interface options:
1. Select the Settings point of view.
2. In the Session pane, click Management Options.
The Management Options window opens.
3. Under Display Options, select User interface options.
The User Interface Options window opens.
4. Under General Options, select a default operating system for new hosts from the list.
This operating system is set as the default when you add a host.
5. Under Display Refresh Options, select or edit the desired settings for the content pane:
Enable refresh—Select this check box to start the refresh interval for the selected pane. If
you do not select this check box, the pane is not refreshed automatically, and you must
manually refresh all panes using the browser refresh tool.
Refresh interval—Enter the amount of time between a refresh of the selected pane (valid
values are 45 to 600 seconds). For example, if you enter 60, the selected pane is refreshed
every 60 seconds.
6. Click Save changes.

Creating page footer messages

Use the Set Page Footer Message options to enter or edit a text message to display at the bottom
of each Content pane for browser sessions on the management server. The message can be a
security message or can contain other applicable information. The maximum length is 64 characters;
the text appears in red.
To set a page footer message:
1. From the settings point of view session pane, click Management Options.
The Management Options window opens.
2. Under Display Options, select Set page footer message.
The Set Page Footer Message window opens.
3. Enter text or edit the existing message in the text box.
4. Click Save Changes.
The new message appears in red at the bottom every Content pane.
Setting user interface options 59