Download
Share
Print this page
HP P6000 Replacement Instructions
  1. Manuals
  2. Brands
  3. HP Manuals
  4. Storage
  5. Pavilion p6000 - Desktop PC
  6. Replacement instructions
HP P6000 Replacement Instructions

HP P6000 Replacement Instructions

Hp storageworks disk enclosure vrm replacement instructions (504218-001, september 2009)
Hide thumbs Also See for P6000:
1
2
3
4

Advertisement

Quick Links

Download this manual See also: Reference Manual, Replacement Instructions
Enlarged version
HP StorageWorks
Disk enclosure VRM replacement
instructions
This document details the procedures for replacing a
failed VRM (voltage regulator module) in an HP storage
enclosure.
© Copyright 2009 Hewlett-Packard Development Company, L.P.
First edition: June 2009
The information in this document is subject to change without notice.
Printed in the US
www.hp.com
*504218-001*

About this document

For the latest documentation, go to
manuals, and select your product.
The information contained herein is subject to change without notice.
The only warranties for HP products and services are set forth in the
express warranty statements accompanying such products and services.
Nothing herein should be construed as constituting an additional
warranty. HP shall not be liable for technical or editorial errors or
omissions contained herein.
WARRANTY STATEMENT: To obtain a copy of the warranty for this
product, see the warranty information website:
go/storagewarranty

Before you begin

Observe the following precautions when replacing a module.
CAUTION:
Parts can be damaged by electrostatic discharge. Use proper
anti-static protection. Refer to the documentation that shipped
with your system for additional information.
NOTE:
Information is also available on hood label.
NOTE:
Illustrations in this document may show modules or a chassis
that differ from your device. However, replacement procedures
are the same for all chassis that use this component.
The VRM is located inside the enclosure chassis.
Page 1
http://www.hp.com/support/
http://www.hp.com/

Advertisement

loading

Related Manuals for HP P6000

Summary of Contents for HP P6000

  • Page 1: About This Document

    Refer to the documentation that shipped with your system for additional information. NOTE: Information is also available on hood label. © Copyright 2009 Hewlett-Packard Development Company, L.P. First edition: June 2009 NOTE: The information in this document is subject to change without notice.

  • Page 2: Verifying Component Failure

    Remove the top access cover. Lift the access panel latch (1). The access panel will slightly Verifying component failure disengage from the enclosure. Slide the access panel to the rear (2) and lift away from the Analyze any failure messages received in the system logs. chassis.
  • Page 3 Disconnect the VRM cables from the backplane. Installing the VRM Thread the VRM cables through the opening in the chassis and then align the replacement VRM on the guide posts on the bottom of the chassis and top of the power supply cage. Slide the VRM into position then push down to seat (1), tighten the Loosen the thumbscrew (T-15 may be needed) securing the VRM thumbscrew (T-15 may be needed) to secure the VRM (2).

  • Page 4: Additional Information

    Connect the VRM cables to the backplane. WARNING! Reinstall drives in the same slot locations. With the drive lever in the open position, reinsert drives fully into each bay, pressing on the lever to secure each drive, remove any labels added to mark the drives. NOTE: Reinstall drives in the same slot locations.