Table of Contents
Advertisement
The eraser selects everything
or will not stop erasing.
You notice a delay at the
beginning of pen or inking
strokes.
You have to press hard with
the pen when clicking,
drawing, or writing.
The pen tip does not function.
The pen tip and screen cursor
do not properly line up.
Changing the function settings
for an input tool has no effect.
The pen side switch does not
work.
The screen cursor moves but
does not jump to the pen tip
location when placed on the
screen, and it does not follow
the pen tip when moving the
pen across the display.
When using Cintiq with one or
more additional monitors, you
cannot use the pen to control
the other monitor(s).
Contents
•
Open the Control Panel and go to the E
F
slider toward F
EEL
C
T
LICK
HRESHOLD
•
If this does not help, see
•
Open the Control Panel and go to the P
•
Decrease the T
•
Make sure the U
unchecked.
•
Move the T
order to turn off double-click assist.
•
Open the Control Panel and go to the P
•
Move the T
decrease the S
•
Be sure you are using only the pen that came with your product, or
a Wacom accessory pen specified for use with the Cintiq. Other
pens may not function properly on the Cintiq.
•
Check the Control Panel P
assigned to the pen tip.
Open the Control Panel and select the C
Calibrating the
Make sure you change the settings for the tool and application that you
are using. See
tools.
•
Be sure you are using only the pen that came with your product, or
a Wacom accessory pen specified for use with the Cintiq. Other
pens may not function properly on the Cintiq.
•
Be sure to press the side switch when the pen tip is within 5 mm
(0.2 inch) of the Cintiq active area. Do this without pressing down
on the pen tip.
•
In the Control Panel, verify that the side switch is set to the proper
function for the application and tool you are using.
•
Check the S
need to first press the side switch, then touch the pen tip to the pen
screen surface in order to perform a click function.
•
Make sure the Wacom driver has loaded properly by opening the
Control Panel. If the driver did not load you will see an error
message.
•
If you have customized the side switch on your pen to toggle
between pen mode and mouse mode, make sure that your Cintiq is
operating in pen mode.
You can use your pen to control the other monitors in mouse mode. To
use mouse mode, first set a pen button to M
the button to toggle between pen mode and mouse mode.
Contents
Index
Index
, or select C
IRM
setting.
Testing controls and input
D
C
D
IP
OUBLE
LICK
W
I
SE
INDOWS
NK
D
C
D
IP
OUBLE
LICK
ISTANCE
F
slider toward S
IP
EEL
and C
ENSITIVITY
LICK
tab and verify that a C
EN
Cintiq.
Application-specific settings
S
M
. If C
IDE
WITCH
ODE
tab. Move the E
RASER
... and increase the
USTOMIZE
tools.
tab.
EN
.
ISTANCE
checkbox on the C
ALIBRATE
slider to the O
position in
FF
tab.
EN
, or select C
OFT
USTOMIZE
T
settings.
HRESHOLD
LICK
tab. Continue with
ALIBRATE
and
Working with multiple
& T
is selected, you will
LICK
AP
T
.... Then use
ODE
OGGLE
54
RASER
tab is
... and
function is
54
Advertisement
Table of Contents
