Preliminary Check Of The Case; Make A Preliminary Submersion Test On The Waterproof Case Before Positioning The Digital Camera - FujiFilm WP-XQ1 Owner's Manual

Preliminary check of the case

Make a preliminary submersion test on the waterproof case before
positioning the digital camera
Before installing the digital camera in the case, make sure that there is no water leakage.
1
Check the outside of the waterproof case to make sure that there are no
cracks or faults with it.
2
Open the waterproof case using the special pick (included).
3
Check the inside of the waterproof case for the following:
open/close knob
O-ring
special pick (included)
➀
Release the lock of the open/close
knob.
➁
Turn the open/close knob in the
direction of the "OPEN" arrow to open
the waterproof case.
When opening or closing the waterproof
case, take care not to catch your fingers
or palm in the case.
You can also use the adjuster of the strap
if you do not have the special pick (pg. 16).
• Cracks (especially around the O-ring)
• Correct seating of the O-ring (For
correct installation of the O-ring, see
page 24.)
• That the O-ring has no scratches
or cracks, or that it is oddly shaped,
twisted, detached, etc.
• Sand or foreign particles stuck to the
O-ring
EN-8