Adjusting The Brakes; Checking And Adjustment Of Throttle Wire; Checking And Adjusting The Choke Wire - Husqvarna Rider Pro 15 Operator's Manual

Adjusting the brakes

The parking brake (on the right) is adjusted as
follows:
1. Remove the transmission cover.
2. Unhook the spring (A) from the screw (B).
3. Make sure the parking brake is released.
4. Adjust so there is 1 mm play between the outer
cable and the adjuster screw when you pull the
outer cable.
Adjust the adjuster screw using the nuts.
5. Tighten the nuts carefully to prevent damaging
the adjuster screw.
6. Refit the spring (A).
7. Check that the brake works.
WARNING!
Poorly adjusted brakes can result
in reduced braking power.
Checking and adjustment of the throttle
wire
Check that the engine responds to the throttle
control and that the correct engine speed is
achieved at full throttle.
If in doubt, contact the service workshop.
If adjustment is necessary, adjust the lower wire as
follows:
1. Release the clamping screw that secures the
wire casing and set the throttle control to full
throttle.
2. Check that the throttle wire is attached to the
correct hole in the lower lever, see diagram.
3. Pull the throttle wire casing to the far left and
tighten the clamping screw.

Checking and adjusting the choke wire

If the engine is producing black smoke or is difficult
to start then the choke wire (upper wire) may be
incorrectly adjusted.
If in doubt contact your service workshop.
If it is necessary to adjust the choke, proceed as follows:
1. Release the clamping screw that secures the
wire casing and set the choke control to
maximum choke.
2. Check that the throttle wire is attached to the
upper lever, see diagram.
3. Pull the choke wire casing to the far right and
tighten the clamping screw.
MAINTENANCE
6020-005
8009-144
8009-145
23
English –