Checking And Adjusting The Brakes - Husqvarna 13 AWD Operator's Manual

Checking the brake Rider 11 and
Rider 11 C
The brake is of the disc brake type and is fitted on
the gearbox.
Check that the brake is correctly adjusted by
measuring the distance between the brake lever
and the front edge of the recess on the chassis.
The distance should be 0–1 mm (0-0.040") when
the brake is not applied.
Adjusting the brake Rider 11 and
Rider 11 C
1. Release the lock nuts (1).
2. Tension the wire with the adjusting screw (2) so
that the distance between the brake lever and
the front edge of the recess on the chassis is
1 mm (0.040").
3. Tighten the lock nuts (1) after adjustment.
Check and adjust the brakes on
Rider 13 C and Rider 15 C
Check that the brakes are correctly adjusted by
placing the rider mower on a shallow downhill slope
and applying the brake.
If the rider mower begins to move then the brakes
must be adjusted.
The brake is adjusted as follows:
1. Release the lock nuts (1).
2. Tension the wire with the adjusting screw (2)
until all the play in the wire is taken up.
3. Tighten the lock nuts (1).
4. On completion of the adjustment the brake
should be re-checked.
WARNING!
Poorly adjusted brakes can result
in reduced braking power.
28
– English
MAINTENANCE
2
1
1
8009-580
6008-012
6008-239H