Husqvarna Rider Pro 15 Operator's Manual page 45

2. Pedal mechanism in frame tunnel
Lubricate the pedal mechanism in the frame tunnel.
Remove the cover from the frame tunnel by
undoing the screws, two on each side.
Pump the pedals and lubricate the moving parts
using an oil can.
Lubricate the wires connected to the brake and
drive pedals using an oil can.
Lubricate as described under "Chains in frame
tunnel" before refitting the cover over the frame
tunnel.
3. Chains in frame tunnel
Remove the cover from the frame tunnel, see step 2.
Lubricate the chains in the frame tunnel using an oil
can or motorcycle chain spray.
Lubricate the shaft of the control wire pulleys with
grease. Press the rollers to the side and brush the
shaft with grease.
Refit the cover over the frame tunnel.
4. Triangular link and joints
Lubricate the triangular link and the joints on the
cutting height adjustment strut behind the right front
wheel.
Lubricate using oil can.
LUBRICATION
6008-211
6020-021
6020-022
8009-155
43
English –