Adjusting The Brakes; Checking The Tyre Pressure - Husqvarna Rider ProFlex 18 Operator's Manual

Adjusting the brakes

The parking brake (on the right) is adjusted as
follows:
1. Remove the transmission cover. Unscrew the
two screws (one on each side) and lift off the
transmission cover.
2. Unhook the spring (A) from the screw (B).
3. Make sure the parking brake is released.
4. Adjust so there is 1 mm play between the outer
cable and the adjuster screw when you pull the
outer cable.
Adjust the adjuster screw using the nuts.
5. Tighten the nuts carefully to prevent damaging
the adjuster screw.
6. Refit the spring (A).
7. Check that the brake works.
WARNING!
Poorly adjusted brakes can
result in reduced braking power.

Checking the tyre pressure

Check tyre pressure (60 kPa, 0.6 bar).
To improve driving the pressure on the rear tyres
can be reduced to 40 kPa (0.4 kp/cm
The maximum tyre pressure is 100 kPa (1.0 kp/cm
IMPORTANT INFORMATION
Different tyre pressures on the front tyres
will result in the blades cutting the grass
at different heights.
MAINTENANCE
2
).
2 ).
A
B
25
English –