Husqvarna Rider Pro 15 Operator's Manual page 46

5. Driver's seat
Tip up the seat.
Lubricate the linkage of the scissor springs using
an oil can; there are 8 lubrication points.
Lubricate the seat leg length adjustment
mechanism using an oil can.
Lubricate the leg length adjustment rails using an
oil can.
6. Throttle and choke wires, lever
bearings
Remove the right side panel from the lever housing
(1 screw) and open the engine hood. Lubricate the
exposed ends of the wires using an oil can,
including the ends at the engine. Move the levers
through their full range of travel and lubricate again.
Lubricate joints, locks and bearings for the cutting
deck control levers using an oil can.
Refit the side panel on the lever housing. Make sure
the tabs engage correctly in the housing.
7. Belt tensioner
Use a grease gun to lubricate the single nipple on
the right side below the lower engine pulley, until
grease is forced out.
Use good quality molybdenum sulphide grease.
Grease with a familiar brand name (petrol company,
etc.) is generally of good quality.
44
– English
LUBRICATION
6020-025
8009-156
8009-157
6008-232