Driving The Machine - Husqvarna Rider Pro 15 Operator's Manual

5. When the engine starts release the ignition key
immediately back to neutral position.
IMPORTANT INFORMATION
Do not run the starter for more than about
5 seconds at a time. If the engine does not
start, wait about 15 seconds before trying
again.
6. Push the choke lever gradually forward when
the engine has started.
7. Set the required engine speed with the throttle
control.
Let the engine run at moderate speed or half
throttle for 3-5 minutes before subjecting it to
heavy load.
WARNING!
Never run the engine indoors, in
enclosed or poorly ventilated
areas. The exhaust fumes con-
tain toxic carbon monoxide.

Driving the machine

1. Release the parking brake by pressing the brake
pedal.
2. Carefully press down one of the pedals until the
required speed is obtained.
To drive forward press down pedal (1), or to
reverse pedal (2).
WARNING!
Make sure that branches do not
obstruct the pedals when mowing
under bushes, otherwise you may
lose control.
16
– English
DRIVING
2 1
6017-136
6017-137
6007-208
6017-229