Switch For Operation Of Cutting Unit; Switch For Extra Hydraulic Function (Hydraulic Kit Option) - Husqvarna PT 26D Operator's Manual

Presentation

22. Switch for operation of cutting unit

The cutting unit can only be started when the driver is sitting in
the seat.
• Pull out the switch to engage cutting unit
operation.
• Press in the switch to disengage cutting unit
operation.
If the safety circuit trips cutting unit operation, the
switch must be pressed in and pulled out again.
The safety circuit trips and the cutting unit stops:
When the cutting unit is raised to the uppermost
position
When the driver leaves the seat. There is a brief delay to
prevent stoppages should the driver bounce in the seat
When high gear is engaged.
When the starter is activated.
23. Switch for extra hydraulic function
(hydraulic kit option)
The switch is used, among others, when steering the
folding plough for individual control of the left or right-
hand plough-blades. Operate the plough blade using
the lever (21).
42
Switch for operation of cutting unit
Switch for extra 12 V outlet