Side Shifting The Cutting Unit - Husqvarna PT 26D Operator's Manual

Maintenance

Side shifting the cutting unit

Cutting unit, Combi 155, can be side shifted 8 cm to
the left or be centrally positioned on the machine.
1. Stop the engine. Switch off the weight transfer switch.
IMPORTANT INFORMATION:
Never leave the propeller shaft on the machine with
one end detached. If the engine starts, damage might
occur.
2. Remove the propeller shaft completely. Pull the
ring to release the quick connector and to be able
to pull the propeller shaft from the shaft journal.
3. Start the engine and raise the cutting unit to the
transport position.
4. Stop the engine.
5. Remove the pins on both sides.
6. Lower the cutting unit to the mowing position.
When the engine has stopped: Ignition switch in
the ON position and the lever in the lowered
position within 3 seconds, otherwise turn the
ignition switch again.
96
Remove the propeller shaft
Remove the pins