Step 17 Dishwasher Wet Test; Step 18 Replace Toekick; Step 19 Literature - GE ZBD6800K Installation Instructions Manual

STEP 17
DISHWASHER WET TEST
Turn on power supply (or plug power cord into
outlet, if equipped).
Start the unit to check for leaks.
– Push RINSE ONLY pad.
– Push START/RESET pad one time.
– Close door.
Check to be sure that water enters the dishwasher.
If water does not enter the dishwasher, check to
be sure that water and power are turned on.
Check for leaks under the dishwasher. If a leak
is found, turn power supply off, then tighten
connections. Restore power after leak is corrected.
Check for leaks around the door. A leak around the
door could be caused by door rubbing or hitting
against adjacent cabinetry. Reposition the
dishwasher if necessary. See Step 12.
The dishwasher will drain and turn off about
5 minutes after it was started. Check drain lines.
If leaks are found, turn power off at the breaker
and correct plumbing as necessary. Restore power
after corrections are made. See Step 14.
Open dishwasher door and make sure most of the
water has drained. If not, check that disposer plug
has been removed and/or air gap is not plugged.
See Step 14. Also check drain line for kinking.
Run the dishwasher through another "Rinse Only"
cycle. Check for leaks and correct if required.
Installation Instructions
STEP 18
REPLACE TOEKICK
• Place toekick against the legs of the dishwasher.
Attachment Screws
Figure HH
• Align the toekick with the bottom edge and make sure
it is against the floor.
• Insert and tighten the two toekick attachment screws.
The toekick should stay in contact with the floor.
TIP: Make sure toekick is against floor to minimize
noise.
STEP 19 LITERATURE
• Be sure to leave complete literature package and
installation instructions with the consumer.
14
T o e k i c k