Table of Contents
Advertisement
Available languages
Available languages
Installation Instructions
STEP 16 - DISHWASHER WET TEST
Turn on power supplylor plug power cord into outlet, if equipped).
Turn on Dishwasher
Select "Normal wash" program.
Close the door. There will be a 5 second pause, followed by a 60 second pump-out.
O
Check to be sure that water enters the dishwasher. If water does not enter the disnwasher.check to
be sure that water and power are turned on.
O
Check for leaks under the dishwasher. If a leak is found,turn power supply off, then tighten
connections. Restore power after leak is corrected.
O
Check for leaks around the door. A leak around the door could be caused by door rubbing or hitting
against adjacent cabinetry. Reposition the dishwasher if necessary.See step 9.
O
The dishwasher will drain about 12 minutes after the first fill. Check drain lines.if leaks are found,turn
power off at the breaker and correct plumbing as necessary. Restore power after corrections are made.
See Step 12.
O
Open dishwasher door and make sure most of the water has drained.if not, check that disposer plug
has been removed and/or air gap is not plugged. See Step 13. Also check drain line for kinking.
O
Run the dishwasher through another fill and drain cycle. Check for leaks and correct if required.
STEP 17 - REPLACE TOEKICK
a"
Adjust Up
_|
"or Down
Install 2 toekick screws to fasten
toekick. Allow the
toe kick to tuch the
floor.
STEP 18 —- LITERATURE
Be sure to leave complete literature package and installation instructions with consumer.
NOTE: The manufacturer, following a policy of constant development and up-dating of the product, may make
modifications without giving prior notice.
12
Advertisement
Table of Contents
