HP 700 Series User Manual page 97

Address section, and Server-assigned address under Name
Server Configuration.
If you selected an ISP from the list, the IP addresses will be
filled in automatically
If you are connecting to a corporate network, or your ISP
was not in the list, you will need to provide the IP
addresses. Contact your ISP or network administrator for more
information. Tap OK to return to the setup wizard.
You also have the option to choose software and IP header
compression options. Ask your ISP if these options are
recommended for your account.
If you have created one Service Provider using HP dialup, you
can create another by tapping the New button on the HP
dialup Service Provider Tab. Then, follow the Setup Wizard to
create a new ISP connection.
Select your service provider's e-mail protocol from the drop-down
list. Inbox supports both the POP3 and IMAP4 protocols. POP3
OpenMail is not supported.
The default options represent the settings used by many ISPs.
If you are not sure, or you do not have guidance from your ISP,
try the default settings.
If your service provider requires you to specify a domain when
you log on (for example, when connecting to a Windows NT
network), select the Network Domain check box, and then type
the domain name in the box.
Depending on your service provider, you may have different
addresses for your incoming mail (POP3 or IMAP4) server and
your outgoing mail (SMTP) server.
Under Connection Options you can choose a variety of settings
for connecting to your e-mail account.
By default, Inbox checks for new messages every 15 minutes
while connected. If you want to change this setting, or if you wish
Chapter 6 | Accessing e-mail | 93