Hangar 9 P-51 Mustang ARF Assembly Manual page 29


Step 4
Plug the servos, switch harness and aileron
Y-harness into the receiver. Plug the receiver battery
into the switch harness.

Step 5
Route the antenna wire through the pre-installed tube
inside the fuselage to the rear of the fuselage. The tube is
located on the pilot's left side in front of the radio tray.
Section 10: Radio and Linkage Installation

Step 6
Install the switch harness into the side of the fuselage
using the hardware provided with the switch harness. The
switch is placed on the side of the fuselage opposite the
engine exhaust.

Step 7
Place the pre-cut radio foam into the fuselage. The
notch faces towards the fuel tank, same as the flat foam.
Place the receiver battery in the opening towards the
fuel tank, and the receiver in the opening near the radio
tray. Tuck the servo and battery leads neatly between the
layers of foam.
29