Advanced Configuration Menu - Extron electronics ISS 408 User Manual

Operation, cont'd

Advanced Configuration menu

Figure 3-13 is a flowchart that shows an overview of the Advanced Configuration
menu, the submenus, and the available settings.
Default
Cycle
Menu
10 sec.
Video & Audio
Configuration
Menu
Output
Configuration
Menu
Advanced
Configuration
Menu
User Presets
Menu
Exit Menu
Menu
Press Next to Exit
Next
Default
Cycle
Figure 3-13 — Advanced Configuration menu flowchart
3-12 Integration Seamless Switcher • Operation
Change this value with
either Adjust knob.
10 sec.
Dissolve Speed
1.0 Second
Time of the dissolve
(Dissolve button)
0.1 – 5.0 seconds
Next
Select top blanking with
the Adjust knob.
Select bottom blanking
with the Adjust knob.
Preview Blanking
Top Bottom
000 000
10 sec.
Select auto imaging
with the Adjust knob.
Select auto presets
with the Adjust knob.
Auto Imaging
< >
Off On
Auto Memories
< >
Off On
10 sec.
Change this setting
with either Adjust knob.
Preview Switch Mode
< >
Stay Swap
10 sec.
Select a test pattern
with the Adjust knob.
Select preview/program
off/on with the Adjust
knob.
10 sec.
Test Pattern
Color Bars
Next Next
Program Preview
Off Off
Set test pattern type
• Color Bars • Alternating pixels
• Film aspect 1.78
• Crosshatch
• 4x4 crosshatch • Film aspect 1.85
• Grayscale • Film aspect 2.35
• Crop • Ramp
Select top blanking with
the Adjust knob.
Select bottom blanking
with the Adjust knob.
Program Blanking
Next Next
Top Bottom
000 000
10 sec.
Change this setting
with either Adjust knob.
Enhanced Mode
Next Next
< >
Off On
10 sec.
Select an input.
Change this setting
with either Adjust knob.
PAL Film Mode
Next Next
Input #2
< >
Off On
10 sec. 10 sec.
If necessary, select
another input and
repeat.
Select blue mode with
the Adjust knob.
Select edge smoothing
with the Adjust knob.
10 sec.
Blue Only Mode
< >
Off On
Edge Smoothing
< >
Off On
• Output blue video
Next
and sync only
• Enhance edges
Change this value with
either Adjust knob.
RGB Delay
Preview 0.8 Seconds
10 sec.
Next
Change both values
simultaneously with
either Adjust knob.
Pixel Phase
Program Preview
016 016
10 sec.
Next
To reset the scaler, press and
hold the Black button until
the reset message appears.
*Adjust knobs do not affect
this submenu.
Reset Unit?
Menu
Press and Hold
BLACK/MUTE
To Reset
Next
10 sec.
2
2