Command/Response Table For Special Function Sis Commands - Extron electronics ISS 408 User Manual

Programmer's Guide, cont'd

Command/response table for special function SIS commands

The syntax for setting a special function is
(such as 35 in the first example below),
delay" in the first example below), and # is the execute command. To view a
function's setting, use
Command
RGB delay and dissolve speed
RGB delay (Triple-Action Switching)
Example:
Dissolve speed
Switch effect
Switching effect
Scaler output settings
Output sync format
Example:
Output polarity
Example:
Blue screen
Blue screen
(blue & sync output only)
Example:
Edge smoothing
Edge smoothing
Example:
Enhanced mode
Enhanced mode
Example:
4-16 Integration Seamless Switcher • Programmer's Guide
# where
X? X?
ASCII Command Response
(host to switcher) (switcher to host)
*3# Dly
X20
35*3# Dly35
*5# Dur
X20
*4# Eff
X29 X29
*6# Syn
X8
1*6# Syn1
*7# Pol
X9 X9
1*7# Pol1
*8# Blu
X3 X3
1*8# Blu1
*16# Fil
X3 X3
1*16# Fil01
*12# Enh
X3
1*12# Enh01
* # where is the value or variable
X n X n
X?
is the function number (such as "set RGB
X?
is the function number.
Additional description
Switching delay of the selected
X20
input to the preview output.
Adjustable in 0.01 second steps
from 0 up to 50 = 5.0 seconds. 0
= 0.0 seconds (default), 1 = 0.1
seconds, 2 = 0.2 seconds, and so
on.
RGB delay set to 3.5 seconds.
Adjustable in 0.1 second steps
X20
from 1 up to 50 = 5.0 seconds. 1
= 0.1 seconds (default), 1 = 0.1
seconds, 2 = 0.2 seconds, and so
on.
Set the switch effect, 00 = cut or
01 = dissolve, used by the Take,
%, command.
00 = RGBHV (default).
X8
01 = RGBS.
RGBHV output signal.
: Horizontal/Vertical polarity
X9
0 = H–/V–
1 = H–/V+
H-/V+ output polarity.
0 = off (normal output).
1 = on (blue video & sync output).
Blue & sync output for setup.
00 = off.
01 = on (default).
Enable edge smoothing.
0 = off.
X3
1 = on.
Enable enhanced mode.
2 = H+/V–
3 = H+/V+