Headset Safety Considerations; Adjusting The Handset, Speakerphone, And Headset Volume - Cisco 7960 User Manual

Adjusting the Handset, Speakerphone, and Headset Volume

Headset Safety Considerations

Warning
Warning
Adjusting the Handset, Speakerphone, and Headset
Volume
Step 1
Note
Cisco IP Phone Models 7960 and 7940 User Guide
2-4
4 Network port (10/100 SW)
5 Access port (10/100 PC)
6 Handset port
7 Headset port
Read these notices before using a headset with your Cisco IP Phone.
Read the installation instructions before you connect the system to its
power source.
This product relies on the building's installation for short-circuit
(overcurrent) protection. Ensure that a fuse or circuit breaker no larger than
120 VAC, 15A U.S. (240 VAC, 10A international) is used on the phase
conductors (all current-carrying conductors).
Follow these steps to adjust the volume on the handset, speakerphone, or headset.
Procedure
Press the up or down Volume button when the handset, speakerphone, or headset
is in use.
If you press the Volume button when none of these are in use, you are
adjusting the ringer volume. For details, see the
Volume" section on page
Chapter 2 How to Use the Handset, Speakerphone, and Headset
3-12.
"Adjusting the Ringer
78-10182-05