Display (Hp Authorized Service Providers Only); Figure 32 - Bottom Case Screws And Rubber Feet - HP OmniBook 800CCT Service Manual

Display
(HP Authorized Service Providers Only)
Required Equipment
Torx #6 screwdriver
Removal Procedure
1. Exit all applications, including Windows.
2. Turn the OmniBook off and remove the battery and ac adapter.
3. Follow the Hard Disk Drive Removal Procedure on page 53 and the Keyboard Removal
Procedure on page 60 to remove these components.
4. Remove the three rubber feet and six screws from the bottom case. See Figure 32.
Rubber Feet - qty
3
(p/n F1030-40018)

Figure 32 - Bottom Case Screws and Rubber Feet

5. Remove the Keyboard Support Plate Screws. Refer to Figure 33 for proper placement of
screws for each of the OmniBook 800s. The F1360 has three screws, while the F1171-
F1175 only have two. Note – If the Keyboard Support Plate Screws are impossible to
unfasten (due to thread corrosion or stripped head), remove the CPU Screws instead,
which can be accessed from the Keyboard Support Plate. The Top Case and Display
62
Bottom Case
Screws - qty 6
M2.0x0.4x6.0
2.5-4.0 in-lb
(p/n 0515-2396)