Removing The Display Assembly (Hp Authorized Service Providers Only) - HP Omnibook XE4100 Service Manual

Removing the Display Assembly
(HP Authorized Service Providers Only)
Required Equipment
• Small Phillips screwdriver.
Removal Procedure
1. Unplug the AC adapter, if present, and remove the battery.
2. Remove the keyboard cover (page 2-10).
3. Remove the two retaining screws from the rear of the notebook.
4. Remove the screws from the left and right antenna PCAs. Relocate the antenna PCAs away from
the display assembly hinges.
5. Disconnect the display assembly cable from the motherboard.
6. Remove the six retaining screws that secure the display assembly to the top case. Note that there is
a grounding strap at the left hinge.
7. Lift the display assembly off of the notebook.
HP Omnibook XE4100/XE4500 Removal and Replacement 2-17