Cpu (Hp Authorized Service Providers Only); Figure 37 - Removing The Cpu - HP OmniBook 800CCT Service Manual

CPU
(HP Authorized Service Providers Only)
Required Equipment
Torx #6 screwdriver
Removal Procedure
1. Follow the Display Removal Procedure to gain access to the CPU.
2. Remove the two CPU screws (see Figure 37).
3. Gently rock the CPU back and forth from front to back to remove from the connector.

Figure 37 - Removing the CPU

Replacement Procedure
1. Ensure the CPU Insulator is positioned over the CPU connector on the Logic PCA.
2. Position the replacement CPU over the connector on the Logic PCA and press firmly but
gently. For F1360 units, please refer to the Heat Transfer Disk information on page 68.
C To avoid damage, apply pressure to the CPU only directly above the
:
AUTION
connector.
3. Replace the remainder of the components and reboot.
CPU Screws
M1.6x0.35x4.0mm
1.0-2.0 in-lb
(p/n 0515-2852)
CPU
CPU Insulator
(p/n F1360-20007)
67