Small Parts (End User Replaceable); Battery Latch; I/O Door; Memory Cover - HP OmniBook 800CCT Service Manual

Small Parts
(End User Replaceable)
The following small parts are all end user replaceable.

Battery Latch

Once the battery is removed (refer to the Battery Removal Procedure on page 50), the battery
latches will slide out of the bottom case. To replace, align the sides of the latches with the
grooves in the slots. Press firmly into place.

I/O Door

To remove the I/O door, open it fully. Flex the middle of the door until the side pins clear the
holes in the back case. Reverse to replace.

Memory Cover

Slide the memory cover off by using the two finger grips. Replace by aligning the edges of the
cover with the slots on the bottom case. Slide firmly into place.

PCMCIA Card Tray

Slide the two tray latches toward each other. Pull the tray out of the card slot. If present,
remove the PCMCIA card from the tray. To replace the tray, insert into the appropriate card slot.
Slide the two latches away from each other to secure the tray.

Rubber Feet

Place a probe or similar device between the rubber foot and the plastic of the bottom case. Pry
upward to pop the foot out. To replace, firmly press the foot into the hole.
59