Pci/Plug And Play Setup Page - ECS Motherboard User Manual

Keyboard Power On
If you enable this item, system can automatically resume by
pressing any keys, hot or power key on the keyboard or typing in
the password. You must use an ATX power supply in order to use
this feature.
PCI / Plug and Play Setup Page
This page sets up some parameters for devices installed on the
PCI bus and those utilizing the system plug and play capability.
CMOS SETUP UTILITY – Copyright (C) 1985-2003, American Megatrends, Inc.
Primary Graphics Adapter
Allocate IRQ to PCI VGA
PCI IDE BusMaster
: Move
F1: General Help
Primary Graphics Adapter
This item indicates if the primary graphics adapter uses the PCI
or the AGP bus. The default AGP setting still lets the onboard
display work and allows the use of a second display card
installed in an PCI slot.
Allocate IRQ to PCI VGA
If this item is enabled, an IRQ will be assigned to the PCI VGA
graphics system. You set this value to No to free up an IRQ.
PCI IDE BusMaster
This item enables or disables the DMA under DOS mode. We
recommend you to leave this item at the default value.
Chapter 3: BIOS Setup Utility
PCI / Plug and Play Setup
AGP
Yes
Disabled
Enter: Select +/-/: Value F10: Save Esc: Exit
F9: Optimized Defaults
31
Help Item
Select which
graphics controller
to use as the
primary boot device.