Features Setup Page - ECS Motherboard User Manual

Features Setup Page

This page sets up some parameters for peripheral devices
connected to the system.
CMOS SETUP UTILITY – Copyright (C) 1985-2003, American Megatrends, Inc.
OnBoard Floppy Controller
Serial Port1 Address
OnBoard IR Port
Parallel Port Address
Parallel Port Mode
ECP Mode DMA Channel
Parallel Port IRQ
OnBoard PCI IDE Controller
Audio Device
Ethernet Device
MODEM Device
OnBoard USB Function
USB Function for DOS
USB 2.0 Controller
*****On-Chip Serial ATA Setting*****
On-Chip Serial ATA
Serial ATA Port0/1 Mode
: Move Enter: Select +/-/: Value F10: Save Esc: Exit
F1: General Help
OnBoard Floppy Controller
Use this item to enable or disable the onboard floppy disk drive
interface.
Serial Port1 Address
Use this item to enable or disable the onboard COM1/2 serial
port, and to assign a port address.
OnBoard IR Port
Use this item to enable or disable the onboard infrared port, and
to assign a port address.
Parallel Port Address
Use this item to enable or disable the onboard Parallel port, and
to assign a port address.
Chapter 3: BIOS Setup Utility
Features Setup
Enabled
3F8/IRQ4
Disabled
378
ECP
DMA3
IRQ7
Both
Enabled
Enabled
Auto
Enabled
Disabled
Enabled
Enhanced Mode
P0-3rd/P1-4th
F9: Optimized Defaults
27
Help Item
Allows BIOS to
Enable or Disable
Floppy Controller.