HP G50 Maintenance And Service Manual page 61

3. Turn the computer display-side up, with the front toward you.
4. Open the computer as far as possible.
5. Disengage the tabs (1) on the outside edges of the keyboard from the keyboard cover.
6. Lift the rear edge of the keyboard (2), and then slide it back until it rests on the display.
7. Release the zero insertion force (ZIF) connector (1) to which the keyboard cable is attached, and
then disconnect the keyboard cable (2) from the system board.
8. Remove the keyboard.
Reverse this procedure to install the keyboard.
Component replacement procedures 53