Table of Contents
Advertisement
2.
Lift the right side of the cover (2), swing it up and to the left, and then remove the cover (3). The
WLAN module compartment cover is included in the Plastics Kit, spare part number
486621-001.
3.
Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE:
The black WLAN antenna cable is connected to the WLAN module "Main" terminal. The
white WLAN antenna cable is connected to the WLAN module "Aux" terminal.
4.
Remove the two Phillips PM2.5×5.0 screws (2) that secure the WLAN module to the computer.
(The edge of the module opposite the slot rises away from the computer.)
5.
Remove the WLAN module (3) by pulling the module away from the slot at an angle.
NOTE:
WLAN modules are designed with a notch (4) to prevent incorrect installation.
Reverse this procedure to install the WLAN module.
Component replacement procedures
51
Hide quick links:
Advertisement
Table of Contents
