Chauvet Q-Spot 560 LED Quick Reference Manual page 5

AC
Power
Fuse
Replacement
DMX
Linking
DMX
Connection
Master/Slave
Connection
This product has an auto-ranging power supply that can work with an input
voltage range of 100~240 VAC, 50/60 Hz.
1.
Disconnect this product/product from the power outlet.
2. Wedge the tip of a flat head screwdriver into the slot of the fuse holder
and pry the safety cap out of the housing, which will pull the installed
fuse.
3.
Remove the blown fuse from the safety cap and replace with a fuse of
the exact same type and rating (T 5 A, 250 V).
4. Insert the fuse holder back in place, and reconnect power.
The Q-Spot™ 560 LED can work with a DMX controller when linked using
a regular DMX serial connection.
If you are not familiar with the DMX standard, please download the DMX
Primer document from www.chauvetpro.com.
The Q-Spot™ 560 LED uses a regular DMX data connection for its DMX
personalities, Basic and Advanced.
Download the Q-Spot™ 560 LED User Manual and refer to the Setup
chapter to learn how to connect this product for DMX operation, and the
Operation chapter to learn in detail how to configure this product for DMX
operation.
The Q-Spot™ 560 LED uses the DMX data connection for its Master/Slave
mode.
Download the Q-Spot™ 560 LED User Manual and refer to the Setup
chapter to learn how to connect this product for Master/Slave operation, and
the Operation chapter to learn in detail how to configure this product for
Master/Slave operation.
Page 5 of 16
Q-Spot™ 560 LED QRG