Customizing Phone Settings; Changing The Lcd Contrast; Adjusting The Ringer Volume - Cisco 7940 User Manual

Chapter 3 Using the Cisco IP Phone 7940/7960
The Cisco IP Phone 7940/7960 supports a four- or six-wire headset jack (Plantronics H series
compatible is required). For information on the headset models supported, see the IP phone information
on http://cisco.getheadsets.com
Adjusting the Handset, Speakerphone, or Headset Volume
Adjust the volume on the handset, speakerphone, or headset by performing the following steps.
Increase the volume of your handset, headset, or speakerphone by pressing the + on the VOLUME
Step 1
button.
Decrease the volume of your handset, headset, or speakerphone by pressing the - on the VOLUME
Step 2
button.
The VOLUME button adjusts the volume for the currently active voice receiver.

Customizing Phone Settings

You can change various settings on your Cisco IP Phone 7940/7960 to ensure that the ringer volume,
ring sound, and LCD contrast are set appropriately for you. These sections describe the changes you can
make:
•
•
•

Changing the LCD Contrast

Perform the following steps to improve the readability of the LCD screen by changing the display
contrast.
Step 1 Press the settings button.
Step 2 Press the Scroll button to highlight Contrast from the Settings menu.
Step 3 Press the Down or Up softkeys to set the desired contrast on the LCD screen.
Step 4 Press the OK softkey to accept your changes.
Press the Back softkey to exit the Settings menu.
Step 5
Press the Back softkey to display the main LCD screen.
Step 6

Adjusting the Ringer Volume

Change the ringer volume by performing the following steps.
OL-1365-01
Changing the LCD Contrast, page 3-3
Adjusting the Ringer Volume, page 3-3
Changing the Ringer Sound, page 3-4
or http://vxicorp.com/cisco.
Cisco SIP IP Phone Model 7940/7960 User Guide
Customizing Phone Settings
3-3