What To Do If - Electrolux EHL2X User Manual

9.4 Lamp
WARNING!
Danger of electrocution! Discon-
nect the fuse before you replace
the lamp.
The lamp and the lamp glass cov-
er can be hot.
Before you change the lamp:
• Deactivate the appliance.
• Remove the fuses from the fuse box or
deactivate the circuit breaker.
CAUTION!
Put a cloth on the bottom of the
interior of the appliance. It pre-
vents damage to the lamp glass
cover and the cavity.
Always use the same lamp type.

10. WHAT TO DO IF...

WARNING!
Refer to the Safety chapters.
The cooking zones do
not operate.
A
45°
Problem
A
Removing the door
1. Open the door as far as it goes.
2.
Press down the clamping levers (A)
on the two door hinges.
3. Close the door until it is at an angle
of approximately 45°.
4. Hold the door with one hand on each
side and pull it away from the appli-
ance at an upwards angle.
Inserting the door
To insert the door do the above steps in
the opposite sequence.
Replacing the top lamp:
1.
2.
3.
4.
Possible cause
Consult the operating instructions for the built-in
cooking surface.
CAUTION!
Be careful when you remove the
door from the appliance. The door
is heavy. There is a risk of injury or
damage to the appliance.
Put the door with the outer side
down on a soft and level surface
to prevent scratches.
Turn the lamp glass cover counter-
clockwise to remove it.
Clean the glass cover.
Replace the lamp with a halogen, 230
V, 40 W, 300 °C heat resistant oven
lamp.
Install the glass cover.
Remedy
ENGLISH 23