Table of Contents
Advertisement
11.1 Installing the oven under a work surface
A
A
A
A
D
A 549
N 550(-0,+1)
A
11.2 Electrical connection
Use a power cable of H05VV-F or higher.
Connect the appliance to a socket supply
line. If there is no socket supply line, the
electrical installation must have an isola-
tion device which lets you disconnect the
appliance from the power supply. The iso-
600
B
ca.50
A
A
435
min. 20
B
10
20
A
WARNING!
Installation into flammable material
must agree with NIN SEV 1000
(Association of Cantonal Fire In-
surers) fire protection guidelines
and regulations.
A = appliance
N = recess
1.
Install the hotplates according to the
installation instruction no.
374307900 / 374307901 so that the
hotplate socket connections can be
carried out before the cooker is inser-
ted. Make sure the correct socket
connections are used.
A separate earthing is not required.
2.
Install the glass ceramic cooking sur-
face and hobs according to the sepa-
rate installation instructions.
3.
Pull the appliance drawer out as far
as it goes, take hold of it and remove
it.
4.
Use the side handles to hold the oven
and slide it flush into the recess.
CAUTION!
Make sure the cable is free when
you move the appliance.
5.
Use at least 2 screws to fix the oven
on both sides (Detail A).
WARNING!
When installing next to a wood-fu-
elled boiler, a heatproof and heat-
insulating plate must be mounted
at the height of the appliance and
at least 30 cm deep.
lation device must have a contact opening
width of minimum 3 mm (in reference to
NIN SEV 1000). The customer must have
a socket for the electrical connection that
is accessible and outside the coordination
room. The length of the connection cable
must be approximately 120 cm with lines
connected directly to the power supply.
ENGLISH
25
Advertisement
Table of Contents
