Table of Contents
Advertisement
Installing the shelf supports
Install the shelf supports in the opposite
sequence.
11.3 Steam generation system
CAUTION!
Dry the steam generator after
each use. Soak up water with the
sponge.
Remove the limescale residue
with water and vinegar.
CAUTION!
Chemical de-scaling agents can
cause damage to the enamel. Fol-
low the instructions of the manu-
facturer.
Cleaning the water drawer and the
steam generator:
1.
Put the water and vinegar mixture
(approximately 250 ml) through the
A
3.
Pull the support out of the rear catch.
water drawer into the steam genera-
tor.
Wait for approximately 10 minutes.
2.
Remove the water and vinegar with
the sponge.
3.
Put clean water (100 - 200 ml) into
the water drawer to flush the steam
generation system.
4.
Remove water from the steam gener-
ator with the sponge and rub dry.
5.
Keep the door open to let the appli-
ance dry fully.
11.4 Removing / inserting the
door
To clean the door remove it.
A
Removing the door
1.
Open the door as far as it goes.
2.
Press down the clamping levers (A)
on the two door hinges.
CAUTION!
Be careful when you remove the
door from the appliance. The door
is heavy. There is a risk of injury or
damage to the appliance.
ENGLISH
19
Advertisement
Table of Contents
