What To Do If - Electrolux EBKGL7 User Manual

20 www.electrolux.com
11.5 Lamp
WARNING!
Danger of electrocution! Discon-
nect the fuse before you replace
the lamp.
The lamp and the lamp glass cov-
er can be hot.
Before you change the lamp:
• Deactivate the appliance.
• Remove the fuses from the fuse box or
deactivate the circuit breaker.
CAUTION!
Put a cloth on the bottom of the
interior of the appliance. It pre-
vents damage to the lamp glass
cover and the cavity.
Always use the same lamp type.
Replacing the top lamp
1.
Turn the lamp glass cover counter-
clockwise to remove it.

12. WHAT TO DO IF...

WARNING!
Refer to the Safety chapters.
45°
3. Close the door until it is at an angle
of approximately 45°.
4. Hold the door with one hand on each
side and pull it away from the appli-
ance at an upwards angle.
Put the door with the outer side
down on a soft and level surface
to prevent scratches.
Inserting the door
To insert the door do the above steps in
the opposite sequence.
2. Remove the metal ring and clean the
glass cover.
3. Replace the lamp with a halogen, 230
V, 40 W, 300 °C heat resistant oven
lamp.
4. Attach the metal ring to the glass cov-
er.
5. Install the glass cover.
Replacing the side lamp:
1. Remove the left shelf support.
2. Use a Torx 20 screwdriver to remove
the cover.
3. Remove and clean the metal frame
and the seal.
4.
Replace the lamp with a halogen, 230
V, 25 W, 300 °C heat resistant oven
lamp.
5. Install the metal frame and the seal.
Tighten the screws.
6. Install the left shelf support.