Buzzer Control; Hotkey Port Switching; Firmware Upgrade Mode; Restore Default Settings - ATEN CS1964 User Manual

Buzzer Control

The buzzer can be turned on or off. To turn the buzzer on/off, do the following:
1. Invoke HSM (see page 24
2. Press and release [B].

Hotkey Port Switching

To enable/disable hotkey port switching, do the
1. Invoke HSM (see page 24).
2. Press [X] [Enter].
When disabled, port switching hotkeys [Scroll Lock] [Scroll Lock] (and the
alternative [Ctrl] [Ctrl]) will not work.

Firmware Upgrade Mode

To enter Firmware Upgrade Mode, do the following:
1. Invoke HSM (see page 24).
2. Key in: upgrade
3. Press [Enter].
The front panel LEDs flash to indicate Firmware Upgrade Mode is in
effect.
Note: To exit Firmware Upgrade Mode, you must power off the switch.

Restore Default Settings

To reset the CS1964 to its default Hotkey settings, do the following:
1. Invoke HSM (see page 24).
2. Press [R] [Enter].
All Hotkey settings return to the factory default settings.
).
Chapter 4. Hotkey Operation
following:
27