Firmware Upgrade Mode; Restore Default Settings; Video Dynasync; Alternative Manual Port Selection Settings - ATEN CS1784A User Manual

Firmware Upgrade Mode

To set the CS1782
1. Invoke HSM (see page 25).
2. Key in: upgrade
3. Press [Enter]. The orange front panel LEDs flash to indicate Firmware
Upgrade Mode is in effect.
Note: To exit Firmware Upgrade Mode, you must power off the switch.
See The Firmware Upgrade Utility, page 37, for details.

Restore Default Settings

To reset the CS1782
following:
1. Invoke HSM (see page 25).
2. Press [R] [Enter].
See Hotkey Default Settings, page 50

Video DynaSync

Video DynaSync is ATEN's exclusive technology that eliminates boot-up
display problems and optimizes resolution when switching between ports. To
invoke Video DynaSync, do the following:
1. Invoke HSM (see page 25)
2. Press [D].
Note: If the monitor is disconnected and reconnected, the CS1782
CS1784

Alternative Manual Port Selection Settings

To toggle between the default and the alternative front panel pushbutton
manual port selection settings, do the following:
1. Invoke HSM (see page 25)
2. Press [S].
See Alternative Manual Port Selection Settings, page 17, for full details.
/ CS1784 to Firmware Upgrade Mode, do the following:
A A
/ CS1784 to its default hotkey settings, do the
A A
re-executes Video DynaSync.
A
Chapter 4. Hotkey Operation
A
/
29