Table of Contents
Advertisement
3.1.6 PnP/PCI Configurations
This section shows how to configure the PCI bus system. It covers
some very technical items and it is strongly recommended that only
experienced users should make any changes to the default settings.
PNP OS Installed
Reset Configuration Data
Resources Controlled By
X
IRQ Resources
PCI/VGA Palette Snoop
Assign IRQ For VGA
Assign IRQ For USB
PCI Slot 1 Use IRQ
PCI Slot 2 Use IRQ
PCI Slot 3 Use IRQ
↑↓→← Move
The settings on the screen are for reference only. Your version may not be
identical to this one.
PNP OS Installed
The default setting is “No”. The BIOS will detect the Plug and Play
devices for some compatible resources.
Reset Configuration Data
Enabled The BIOS will reset the Extended System Configuration
Data (ESCD) once automatically. It will then recreate a
new set of configuration data.
Disabled The BIOS will not reset the configuration data.
Resources Controlled By
The Award Plug and Play BIOS has the capability to automatically
configure all of the boot and Plug and Play compatible devices.
Auto(ESCD) The system will automatically detect the settings for
Manual
Phoenix - AwardBIOS CMOS Setup Utility
PnP/PCI Configurations
No
Disabled
Auto(ESCD)
Press Enter
Disabled
Enabled
Enabled
Auto
Auto
Auto
Enter:Select
+/-/PU/PD:Value F10:Save
F5:Previous Values
F6:Fail-Safe Defaults
you.
Choose the specific IRQ resources in the “IRQ
Resources” field.
Award BIOS Setup Utility
Item Help
Menu Level
Default is Disabled.
Select Enabled to
reset Extended System
Configuration Data
(ESCD) when you exit
Setup if you have
installed a new add-on
and the system
reconfiguration has
caused such a serious
conflict that the OS
cannot boot.
ESC:Exit
F1:General Help
F7:Optimized Defaults
3
81
Advertisement
Table of Contents
