Table of Contents
Advertisement
3
Award BIOS Setup Utility
IRQ/Event Activity Detect
Move the cursor to this field and press <Enter>. The following fields
will appear.
PS2KB Wakeup Select
USB Resume from S3
If you are using the Wake-On-USB Keyboard/Mouse function
with a device that is connected to the USB 1.1 por t, set this
field to Enabled. This function allows you to use a USB keyboard
or USB mouse to wake up a system that is in the S3 (STR -
Suspend To RAM) state.
VGA
When set to On, the system will respond and wake up to any
VGA activity.
LPT & COM
Select the port you would like the system to respond and wake
up when an event occurs on that por t.
HDD & FDD
When set to On, the system will respond and wake up to any
hard drive or floppy drive activity.
PCI Master
When set to On, the system will respond and wake up to any
PCI or bus master activity.
78
Password
To use a password to wake up the system, select
this option then press <Enter>. Enter your
password. You can enter up to 5 characters. Type
in exactly the same password to confirm, then
press <Enter>.
Important:
If you forgot the password, you must
power-off the system, unplug the power
cord and clear the CMOS data. Follow the
steps in the “Jumper Settings for Clearing
CMOS Data” section in chapter 2.
Ctrl+F1
Use the <Ctrl> and <F1> keys to wake up the
system.
Disabled
Disables the keyboard password function.
Advertisement
Table of Contents
