Belkin PM11-UL/RAMA User Manual page 34

2
Hardware Installation
Pin
1
2
3
4
5
Pin
1
2
3
4
5
Wake-On-USB Keyboard/Mouse
The Wake-On-USB Keyboard/Mouse function allows you to use a
USB keyboard or USB mouse to wake up a system that is in the
S3 (STR - Suspend To RAM) state.
If you are using this function with a device that is connected to the
USB 2.0 port, you need to configure 2 jumpers. Refer to “Jumper
Settings for Wake-On-USB 2.0 Keyboard/Mouse” in chapter 2. You
also need to enable “Resume on PCI Event” (“IRQ/Event Activity
Detect” field) in the Power Management Setup submenu of the
BIOS.
If you are using this function with a device that is connected to the
USB 1.1 port, you do not need to configure any jumpers. You only
need to enable “USB Resume from S3” (“IRQ/Event Activity Detect”
field) in the Power Management Setup submenu of the BIOS. Refer
to chapter 3 for more information.
34
USB 1.1 (J17)
Function Pin
6
VCC
UP2- 7
UP2+ 8
Ground 9
Key 10
USB 2.0 (J12)
Function
5V_Dul
5V_Dul
Data-
Data-
Data+
Pin
Function
11
VCC
12
UP3-
13
UP3+
14
Ground
15
Ground
Pin Function
Data+
6
Ground
7
Ground
8
Key
9
Ground
10
Function
Ground
Ground
UP2+
UP2-
VCC