Belkin PM11-UL/RAMA User Manual page 71

Super IO Device
Move the cursor to this field and press <Enter>. The following fields
will appear.
Onboard FDC Controller
Enabled Enables the onboard floppy disk controller.
Disabled Disables the onboard floppy disk controller.
Onboard Serial Port 1 and Onboard Serial Port 2
Auto The system will automatically select an I/O address
for the onboard serial por t 1 and serial port 2.
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3
manually select an I/O address for the onboard
serial port 1 and serial port 2.
Disabled Disables the onboard serial port 1 and/or serial
por t 2.
SC Port Address/IRQ (PM11-UL/RAMA only)
This field is used to select the SC port’s address and IRQ. When
selecting an address for the SC por t, the IRQ will at the same
time appear next to the address selected.
MS Port Address/IRQ (PM11-UL/RAMA only)
This field is used to select the MS port’s address and IRQ. When
selecting an address for the MS port, the IRQ will at the same
time appear next to the address selected.
SD Port Address/IRQ (PM11-UL/RAMA only)
This field is used to select the SD por t’ s address and IRQ. When
selecting an address for the SD por t, the IRQ will at the same
time appear next to the address selected.
Important:
IRQs for Serial Port 1, Serial Port 2, Parallel Port, SC Port, MS
Port and SD Port must be appropriately selected making
sure each port uses a different IRQ. When selecting a port
address for SC Port, MS Port and SD Port, the IRQ will at the
same time appear next to the address selected. For
example, if you selected “700/3” for the SC port, “700” is
the port’s address and “3” is its IRQ. Therefore you must
not select IRQ 3 for the other ports.
Award BIOS Setup Utility
Allows you to
3
71