Electrical Connection; General; Emergency Stop Device; Supply Cable And Safety Devices - Maytag MFS 25 Installation And Maintenance Manual

4.5. ELECTRICAL CONNECTION

4.5.1. GENERAL

WARNING !
!
THE MACHINE MUST BE CONNECTED TO THE POWER, GROUND, WATER, VENTILATION AND STEAM
SUPPLY ACCORDING TO THE INSTALLATION MANUAL, IN COMPLIANCE WITH THE VALID LOCAL STANDARDS
DONE BY QUALIFIED TECHNICIANS WITH PROPER AUTHORIZATION.
THE VALID STANDARDS FOR CONNECTING TO THE LOCAL POWER NETWORK (TT / TN / IT, ...) MUST BE
FOLLOWED. IN THE STANDARD EXECUTION, THE WASHER MAY NOT BE SUITABLE FOR CONNECTING
TO AN IT SUPPLY SYSTEM.
THE WASHER EXTRACTOR IS INTENDED TO BE PERMANENTLY CONNECTED TO THE ELECTRICAL
SUPPLY.
The machines have been designed for connecting to the electrical network according to the specifications of your
order. Before connection check if the electrical values stated on the serial plate of the machine correspond
to your electrical network. If not do not connect the machine, please contact your dealer.
If the machine is not equipped with a supply disconnecting device, like a main switch then a supply disconnecting
device need to be provided in the installation for all electrical supplies connected to the machine, in accordance
with EN 60204-1 standard, point 5.3. This device shall disconnect the electrical equipment of the machine
from the supply when required e.g. maintenance.

4.5.2. EMERGENCY STOP DEVICE

The machines are equipped with an emergency stop device in accordance with ISO13850 - category 0 stop
function. Nevertheless, the emergency stop device is omitted on machines design for coin, token, external
payment system or similar operation for use in self-service situation. The owner-installer-user must provide
remote-located emergency stop device(s). This emergency stop device(s) needs to stop each machine
in accordance with ISO13850 - category 0. There are made provisions in the wiring harness, were immediate
removal of power to the actuators can be accomplished. See the electrical schematic of the machine for correct
connection of the device.

4.5.3. SUPPLY CABLE AND SAFETY DEVICES

MACHINE
Fig. 4.5.A. Example of electrical connection
12 INSTALLATION AND MAINTENANCE MANUAL PUBLICATION DATE Sep 05 100646