Star Trac Fitness E-ST 5090 Owner's Manual page 13

Ground Wire
(b) It is now time to attach the display.
NOTE: This step
Quick Disconnect
J4
Heart Rate
assumes that you will be attaching the LED display. Should you
Board
be installing the embedded display or adding a PVS kit, please
Board
refer to those applicable manuals. The following display con-
nections will need to be made: connect the main display cable
to the connector labeled J4 on the display PCB, connect the
heart rate grip cable to the heart rate board, and connect the
ground wire from the heart rate board to the quick disconnect
tab on the display weldment.
(c) With the display electrical connections made, you can now
attach the display. There are 2 tabs located on the bottom of the
display weldment, so in order to attach the display, you will first
2
ND
need to guide the bottom of the display under the tabs and then
second you will need pivot the display forward around the tabs to
mate the display to the rear plastics. Once in place, you can attach
the screws.
1
ST
M4 x 0.7
Screws
(d) With the display in place, attach the 8 M4 x 0.7 screws provided.
6 screws go around the rear of the display and 2 go near the under-
side of the cupholders as shown.
5. Installing the Handrails
NOTE: It is recommended that this step be performed by at least 2 people.
(a) With the assistance of another person, tip the STAR TRAC E-ST STEP-
PER forward and hold in place while completing the following steps.
(b) Remove the 2 rear leg levelers.
(c) Slide the left handrail into the upper end of the left handlebar
weldment and line up the screw holes.
(d) Loosely attach 2 supplied button head screws to the left handlebar
weldment junction using a 5/32" (4mm) hex key or T-handle.
STAR TRAC E-ST STEPPER O ' M 13
WNER S ANUAL