Getting Started; Battery Installation - VTech InnoTab 2 User Manual

Wrist Strap Fastener
Battery Door Lock Sliding
Switch
SD Card Slot
Battery Compartment
Stand

Battery Installation

• Make sure the tablet is turned off.
• Locate the battery door lock sliding switch on the
back of the tablet. Slide the switch to open the
battery door, then remove the door.
• Insert 4 AA batteries as shown in image 2.
• Make sure to replace the battery cover.
Battery Notice
• Use only batteries of the same or equivalent type
as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-zinc)
or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
4
If you wish, attach a wrist strap here. (NOTE:
Wrist strap not included.)
Slide this switch to open the battery door.
Always replace the InnoTab
after changing batteries.
Insert an SD memory card (not included).
(NOTE: InnoTab
®
SDHC memory cards up to 32GB.)
Insert 4 AA batteries (not included). For
battery installation instructions, please see
the next section.
Pull out this stand to prop up InnoTab
use it as a digital photo frame.
2 battery door
®
2 is compatible with SD and
1
2
2 and
®